Toshiba e-STUDIO281c Service Manual page 206

[D] Color developer toner supply clutch (CLT8), color developer drive clutch (CLT9) and black devel-
oper drive clutch (CLT10)
(1) Take off the developer motor (
Developer motor (M11)").
(2) Release the harness from 3 harness clamps.
(3) Remove 1 clip and1 bushing.
(4) Remove 4 screws and take off the bracket.
(5) Disconnect 1 connector, remove 1 gear, 2
bushings and 1 clip, and then take off the
color developer toner supply clutch.
Note:
Place the stopper when installing the clutch.
e-STUDIO281c/351c/451c
DRIVE SYSTEM
P.9-11 "[B]
Gear
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
9 - 12
Fig. 9-16
Bracket
Bushing
Clip
Fig. 9-17
Bushing
Clip
Color developer toner supply clutch
Fig. 9-18
Connector
Bushing