Toshiba e-STUDIO281c Service Manual page 302

(5) Remove 1 E-ring and shaft and then take off
the color auto-toner sensor case.
(6) Remove 2 screws and take off the color
auto-toner sensor.
<<Procedure for replacing an oil seal>>
• Take off the oil seal by hooking out its inside
with a fine screwdriver and such.
• Push in a new oil seal parallel to the frame,
bushing and so on with paying attention to its
direction (as shown by the figure at right).
• Spread the grease (Alvania No.2; about 2-
ricegrain's amount) all around the inside
diameter.
Note:
Wipe off the grease which has run off to the
inner side of the oil seal.
e-STUDIO281c/351c/451c
DEVELOPER UNIT
Shaft
Auto-toner sensor case
Inside
Grease
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
12 - 32
Fig. 12-61
Color auto-toner sensor
Fig. 12-62
Outside
Oil seal
Fig. 12-63