Toshiba e-STUDIO281c Service Manual page 259

3. Push all of the 3 transfer belt drive cou-
plings on the rear frame toward the
center of the shaft, and check if these
couplings are engaged with the shaft
correctly.
4. Check if there is any breakage, defor-
mation or looseness of the transfer belt
drive couplings on the transfer belt unit.
[C] Drum
(1) Take off the process unit
( P.11-10 "[B] Process unit").
(2) Take off the main charger unit (
"[D] Main charger unit").
(3) Remove 1 screw on the front side and 1
screw on the rear side. Then loosen 1 screw
on the front side and disconnect 1 connector.
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
P.11-15 Connector
11 - 13
06/07
Fig. 11-15
Fig. 11-16
Fig. 11-17
e-STUDIO281c/351c/451c
DRUM RELATED SECTION
11