(4)
Loosen 1 setscrew and take off the drawer
feed clutch.
Note:
Attach the clutch to the shaft referring to the
figure at right.
[C] Tray drive unit
[C-1]
Tray-up motor (M10)
(1)
Remove the upper and lower drawers.
(2)
Take off the filter bracket
(
P.2-41 "[K] FIL board (FIL)").
(3)
Disconnect 1 connector. Remove 4 screws
and take off the tray drive unit.
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Setscrew
Fig. 10-47
0.2~0.5mm
Fig. 10-48
Tray drive unit
Fig. 10-49
10 - 23
Drawer feed clutch
e-STUDIO281c/351c/451c
PAPER FEEDING SYSTEM
10