[F]
Fuser belt
(1)
Take off the fuser roller
(
P.16-23 "[E] Fuser roller / Fuser belt
guide").
(2)
Lift up the fuser belt unit and take it off.
Note:
Be careful not to scratch the fuser belt. Lay
the fuser belt on the clean place to prevent
the belt from the dust.
(3)
Remove 1 screw and take off the bracket on
the front side.
(4)
Remove 1 screw and take off the bracket on
the rear side.
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Fuser belt unit
Fig. 16-28
Screw
Bracket
Fig. 16-29
Fig. 16-30
16 - 25
Bracket
Screw
e-STUDIO281c/351c/451c
FUSER UNIT / PAPER EXIT SECTION
16