Toshiba e-STUDIO281c Service Manual page 233

[B] Drawer feeding unit
[B-1] Drawer feeding unit
(1) Take off the upper and lower drawers.
(2) Remove 1 screw and take off the drawer
feeding unit by sliding it to the front side.
[B-2] Tray-up sensor (S27/S28) / Empty sensor (S29/S30)
(1) Take off the drawer feeding unit (
"[B-1] Drawer feeding unit").
(2) Disconnect the connector and release the
latch to take off the tray-up sensor.
(3) Disconnect the connector and release the
latch to take off the empty sensor.
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Drawer feeding unit
P.10-19
Empty sensor
10 - 19
Fig. 10-36
Tray-up sensor
Fig. 10-37
e-STUDIO281c/351c/451c
PAPER FEEDING SYSTEM
10