Toshiba e-STUDIO281c Service Manual page 236

(3) Remove 3 E-rings, pulley, one-way clutch
and take off the pickup roller.
[B-7] Drawer feed clutch (CLT2/CLT3)
(1) Take off the drawer feeding unit (
"[B-1] Drawer feeding unit").
(2) Disconnect the connector and release the
harness from the harness clamp.
(3) Remove 2 screws and take off the clutch
bracket and bushing.
Note:
Match the protruding portion of clutch with
the position shown in the figure for assem-
bling
e-STUDIO281c/351c/451c
PAPER FEEDING SYSTEM
Pickup roller
P.10-19
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
10 - 22
E-ring
One-way clutch
Pulley
Fig. 10-44
Connector
Fig. 10-45
Bushing
Clutch bracket
Fig. 10-46
E-ring