Toshiba e-STUDIO281c Service Manual page 258

Hide thumbs Also See for e-STUDIO281c:

Table of Contents

Hold A, B, C and D as shown in the right-

hand figure when handling the process unit.

At the installation of the process unit, if it cannot be fully inserted, the couplings which transmit

driving force to the transfer belt may be interfering with the unit. Perform the following check, and

then install the process unit again.

1. Rotate the transfer belt drive couplings

on the rear frame of the equipment

counterclockwise by 180 degrees.

2. Push all of the 3 transfer belt drive cou-

plings on the rear frame to the inside,

and check if they have slid back to their

original position.

e-STUDIO281c/351c/451c

DRUM RELATED SECTION

E-studio351c E-studio451c