Toshiba e-STUDIO281c Service Manual page 328

[C] 1st transfer roller
(1) Take off the transfer belt
( P.14-10 "[B] Transfer belt").
(2) Remove 1 screw.
(3) Take off the holder on the rear side and take
off the 1st transfer roller.
[D] Transfer belt home position sensor-1 (S15)
(1) Take off the transfer belt
( P.14-10 "[B] Transfer belt").
(2) Remove 1 screw and take off the cover.
(3) Disconnect 1 connector and remove 1 screw.
Then take off the transfer belt home position
sensor-1.
e-STUDIO281c/351c/451c
TRANSFER UNIT
1st transfer roller
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
14 - 12
Holder
Screw
Fig. 14-15
Cover
Fig. 14-16
Transfer belt
home position sensor-1
Fig. 14-17