Toshiba e-STUDIO281c Service Manual page 296

(6) Remove the following parts installed on the
shaft of the developer sleeve in order: E-ring,
bearing, gear, bearing and oil seal.
* Procedure for replacing an oil seal:
P.12-32 "Fig. 12-63 "
(7) Take off the developer sleeve.
[B-5] Mixer
(1) Discharge the developer material
( P.12-23 "[B-2] Developer material").
(2) Take off the developer sleeve
( P.12-25 "[B-4] Developer sleeve").
(3) Front side: Remove the following parts in
order: E-ring, bushing-1 and bushing-2.
* Procedure for replacing an oil seal:
P.12-32 "Fig. 12-63 "
e-STUDIO281c/351c/451c
DEVELOPER UNIT
Bushing-2
E-ring
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
12 - 26
Fig. 12-43
Developer sleeve
Fig. 12-44
E-ring
Bushing-1
Fig. 12-45