Toshiba e-STUDIO281c Service Manual page 212

(21) Disconnect 1 connector, remove 2 bushings,
1 gear and 2 clips. Remove one-way clutch
and then take off the upper transport clutch
(Low speed).
(22) Remove 9 screws and take off the cover of
the transport motor drive unit.
[F] Transport motor (M9)
(1) Take off the ozone exhaust fan with the
ozone exhaust duct (
exhaust fan (M18)").
(2) Disconnect 1 connector.
(3) Release 1 lock support, remove 2 screws,
and take off the transport motor.
e-STUDIO281c/351c/451c
DRIVE SYSTEM
P.11-24 "[R] Ozone
9 - 18
Bushing
Clip
Upper transport clutch ( Low speed )
Fig. 9-34
Cover
Fig. 9-35
Fig. 9-36
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
One-way
clutch
Gear
Bushing
Transport motor