Toshiba e-STUDIO281c Service Manual page 331

Hide thumbs Also See for e-STUDIO281c:

Table of Contents

[H] Transfer belt cleaner auger motor (M2)

Take off the process unit

P.11-10 "[B] Process unit").

Disconnect 1 connector and remove 1 har-

ness clamp itself.

Remove 2 screws and take off the transfer

belt cleaner auger motor with its bracket.

Remove 2 screws and take off the transfer

belt cleaner auger motor from its bracket.

2nd transfer roller

Open the 2nd transfer unit.

Remove 1 clip, 1 collar (with bearing), 1

washer and 1 bushing (with bearing) on the

front side of the 2nd transfer roller.

Remove 1 clip and slide 1 bushing (with

bearing) on the rear side of the 2nd transfer

Take off the 2nd transfer roller.

Transfer belt cleaner

e-STUDIO281c/351c/451c

TRANSFER UNIT

E-studio351c E-studio451c