No.
Message
84
Misfeed in copier
Press [HELP]
85
Call for service
86
Please try again after
a while
87
Set standard size
e-STUDIO281c/351c/451c
CONTROL PANEL
State of equipment
Paper jam in the equipment
•
Displayed when paper jam
occurred in the equipment
Displayed when motor, sensor,
switch, etc. do not work properly
Displayed when the Department
Code can no be keyed in immedi-
ately after power-ON.
Displayed when the paper size which
is not acceptable is set (depends on
the setting)
5 - 8
Remove the paper in the equipment
according to the messages displayed
on the panel.
Turn OFF the power and solve the
problem, then turn ON the power.
Leave it for a while and key in the
code again
Reset the paper size
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Note