Setting from the Operator Panel Manually to Connect
Set the wireless LAN access point information (the SSID, encryption method and encryption
key) manually to connect to the wireless LAN.
Set by following the procedure below.
1.
Check the SSID and encryption key by referring to the instruction
manual that is included in a wireless LAN access point or other
documents, and write the information down.
Note
If the encryption method is WPA2-EAP, set from the Web page of this machine.
For details, open the Web page of this machine and click [Admin Setup] > [Network] >
[Wireless Setting] > [Manual Setup].
Open the Web Page of This Machine
Memo
An SSID is also called a network name, ESSID, or ESS-ID.
An encryption key is also called a network key, security key, password, or Pre-shared
Key.
2.
Check that the wireless LAN access point starts and is operating
properly.
3.
Turn the machine on.
Memo
If the following screen is displayed, press [Yes], and then proceed to step 6.
4.
Press [Device Settings].
5.
Press [Wireless Setting].
1101