Wpt & Rte Input - Uploading Waypoints Into The Receiver - Leica MX400 Operating Instructions Manual

Operator's Manual
choices are Yes (default) and No.
AWA Offset: Allows you to input a constant angle correction value.
AWS Correction Factor: Allows you to input a wind speed correc-
tion factor.
Input Sentence: Specifies the NMEA 0183 data sentence to read the
depth data from. The available choices are Any (default), MWV,
or VWR sentence. It is better to specify the appropriate sentence,
because more than one method of reporting wind may be
available on the port.
Wpt & Rte Input - Uploading Waypoints Into the receiver
This screen enables the input data port to receive waypoints and
routes from a chart plotter, PC, or other device to the receiver. You
can receive this data through any of the 4 NMEA 0183 input data
ports. Load the WPL sentences first, then the RTE sentenes. Change
Transducer Connected from No (default) to Yes and select the
appropriate port. Refer to the Waypoints - Uploading Waypoints
From Other Devices section of this manual for more details on the
software interface. Refer to the Installation & Service Manual for
hardware interfaces.
154
Datum List
Version 3.2