Rte - Active Route - Leica MX400 Operating Instructions Manual

Operator's Manual
can be set on or off (default on).

RTE - Active Route:

Waypoint identifiers, listed in order with starting waypoint first, for
the identified route. Two modes of transmission are provided: 'c'
indicates that the complete list of waypoints in the route are being
transmitted; 'w' indicates a working route (active) where the first
listed waypoint is always the last waypoint that has been reached
(FROM), while the second listed waypoint is always the waypoint
that you are currently heading toward (TO). The remaining list of
waypoints represents the remainder of the route.
RTE can be sent as version 2.1 and 2.0.
field#: 2 3 4 5 6
³ ³ ³ ³ ³
5 6 7
$GPRTE,x,x,a,cccc,cccc,.....,cccc,cccc*hh<CR><LF>
explanation / actual use:
2: Total number of messages being transmitted (a single route
may require the transmission of multiple messages). A
maximum of 11 waypoints are transmitted in each mes-
sages.
3: Message number.
4: Message mode: c = complete route, all waypoints, w =
working , 1
remaining are the rest. c/w
can be set to c or w (default w).
5: Route identifier, always 00 (Active Route only).
6 - 16: Waypoint identifiers, (less than 11 waypoints may be in
the message).
The number of remaining waypoints can be set to 1, 2 or
'all' (default all) shortening the drawn track on the plotter.
64
1 1 1
st
listed waypoint is 'FROM', 2
Waypoint
nd
is 'TO' and
Version 3.3