Appendix C- Engineering Mode; Aux7 - Unit Information & Self Test - Leica MX400 Operating Instructions Manual

Appendix C - Engineering Mode

Appendix C- Engineering Mode

The Engineering Display, which is activated in CFG1 Operation,
enables an expanded series of display screens in some of the
functions. In general, these screens are used by the technician
during troubleshooting, or by Leica engineers during testing and
software debugging. This section describes what information is
relevant to you, or the information we need to help you trouble-
shoot your receiver.
Note: Information which is not described here is
Unsupported, which means Leica will not
expand or provide any more information than
what is provided in this manual.
If you should enable these screens, they will be automatically
turned off the next time power is cycled on the receiver.
AUX7 - Unit Information & Self Test
When the Engineering Display is active, the AUX7 screen adds one
line of detail to display the engineering level that is turned on:
In addition, you can press the E function key and run a complete
self test by pressing the Make Selftest softkey. The first display of
the self test is a keypad test. Press each function and softkey once.
When you have pressed each once the test will automatically
advance to the Traffic Light test. Observe that the three traffic lights
go from dim to bright. Press OK if they illuminate correctly or Fail
if they don't.
Version 3.3
Operator's Manual
175