Uploading Waypoints From Other Devices - Leica MX400 Operating Instructions Manual

Operator's Manual
1 stop bit
Parity - none
Flow Control - none
Connector - Com1 (or Com2, depending where the external
interface is)
Parity Check - blank
Carrier Detect - blank
OK
16. Click on the Transfers menu
17.Double click on the Receiver Text File menu item and make the
following settings:
[give the file a name.txt]
[select a location (folder) to store the file]
OK
18.On the receiver, you should still be in edit mode on CFG1
NMEA Out 2 with the cursor flashing on Off at the WPL record.
Press the Send All softkey.
19.When all the waypoint sentences are sent, click on the Stop
button on the PC
20. Press the E key on the receiver to exit the edit mode

Uploading Waypoints From Other Devices

The receiver will accept waypoints from any device which follows
the WPL formats identified earlier in the Waypoint section. The first
two characters following the $ can be any NMEA defined talker ID.
You do not have to calculate and include the checksum; however,
you must end each data record with a carriage return and line feed.
If you do include the checksum at the end of the data record, the
receiver will verify the checksum. If the checksum is invalid, the
waypoint will be rejected.
Waypoints received on the data port will be stored to the waypoint
location specified in the WPL record. If the waypoint location
specified in the WPL record is already occupied, the receiver will
over write the existing waypoint (if it is unlocked). If the existing
waypoint is locked, the WPL record received on the input port will
be ignored and dropped.
The receiver will only recognize waypoints from one input port at
any given time. This port is defined in CFG1 WPT & RTE In.
68
Waypoint
Version 3.3