Nav2 - Basic Steering Information - Leica MX400 Operating Instructions Manual

Operator's Manual
graphic screen.
If you drift outside of your cross-track error limit and you decide
not to return to your original course line, you can reset your course
line from your present position to the waypoint by selecting Reset
XTE from the display.
The Skip Waypoint softkey allows you to skip the waypoint you are
presently going to, and advance to the next waypoint. For example,
if you were under way and nearing waypoint 5 and you decide you
want to go on to waypoint 6 now, press Skip Waypoint. If you make
a mistake and you want to go back (unskip) to waypoint 5, you can
do this by:
1. Go into the RTE1 screen.
2. Press E in the RTE1 screen,
3. Select the Route Control softkey,
4. Press the up arrow softkey (fourth from the left) once.
5. Press the E key again.
Refer to the Route section of this manual for more details about
skipping and unskipping waypoints.

NAV2 - Basic Steering Information

Navigate screen 2 provides the bearing (BRG) and range (RNG) to
the waypoint you are approaching in large easily viewed characters.
Below these, you will see your actual Course Over Ground (COG)
and Speed Over Ground (SOG). The bottom portion of the screen
provides cross-track error information. Again, if you don't see the
information described here on your screen, you will need to create a
route in RTE1 first (refer to the Route section of the manual).
24
Navigate
Version 3.3