Uploading Waypoints From A Personal Computer - Leica MX400 Operating Instructions Manual

Waypoint

Uploading Waypoints From A Personal Computer

You can use any terminal or communications program to download
or upload waypoints and routes to or from the receiver and a PC.
Set the PC to:
4800 baud
8 bits
1 stop bit
no parity
no flow control
When sending data to the receiver, it must be sent in block form,
followed by (with an appended) CR (carriage return) and LF (line
feed). Normal communications programs, like the Windows 3.1 or
3.11 Terminal program are sufficient to get the job done. Unfortu-
nately Windows 95 doesn't provide a basic terminal emulation
program, therefore, a third party program is required with Windows
95.
Using Windows Terminal, do the following (from the Program
Manager):
1. Connect the receiver's port 2 RS-232 port to the PC's communi-
cations port (Refer to the Installation & Service Manual)
2. On the receiver, press the CFG key until CFG1 screen is
displayed
3. Scroll down the menu to WPL Input
4. Press the E key
5. Set the Transducer Connected to Yes
6. Set the Data Input Port No. to 2
Version 3.3
Operator's Manual
69