Choose In Bank - Leica MX400 Operating Instructions Manual

Route
6. When you have found the waypoint you want, press the
Insert This WPT softkey.
7. You can then choose to select another waypoint using the
same method, select Escape to go back one level and use
another method to enter waypoints, or select Done to go back to
the main menu.
8. Don't forget to press the E key to end your editing.

Choose In Bank

The following example assumes RTE1 is empty. Follow the
directions in the Erasing An Existing Route section to start with an
empty route if you have waypoints in the RTE1 screen.
1. Select the RTE key until the RTE1 screen is displayed.
2. Press the E key to enter the edit mode.
3. Select Insert from the display. Skip to the next step if RTE1 is
empty.
4. Select Choose In Bank from the display.
5. Select a waypoint by either:
A. Press the Sort By softkey to arrange the waypoints by
number, name, type, distance, or age (refer to the Waypoint
section for a full description), then use the cursor key to
scroll through the previously stored waypoints in the
Waypoint Bank.
B. Press the Search For WPT softkey. When using this selection
you actually spell out the name and or symbols of the
waypoints you are looking for and the software will display
any waypoint containing that combination of characters or
symbols. Refer to the Waypoint section for a full description.
Version 3.3
Operator's Manual
39