Removing Waypoints - Leica MX400 Operating Instructions Manual

Operator's Manual

Removing Waypoints

Unlocked waypoints can be over written by waypoints received on
the NMEA port containing the same waypoint number, by the Mark
function or the MOB function. The Mark and MOB functions start
storing waypoints beginning at waypoint 1999 and work their way
backwards. When the Waypoint Bank is full, this process starts
again at 1999 and begins over writing each unlocked waypoint in
sequence, beginning at 1999. Waypoints that are contained within a
stored route can not be removed until they are removed from the
stored route in the RTE2 screen. If you try to remove a waypoint
stored in a route, a warning will be displayed indicating the first
route a waypoint is stored in.
If the waypoint you want remove is locked, refer to the Waypoint
Lock/Unlock section for a step by step procedure, return to this
section.
To remove a wayoint:
1. Select the WPT key until the WPT1 screen is displayed.
2. Move the cursor to the desired waypoint.
3. Press the E key.
4. Press the Remove softkey.
There are three methods to remove waypoint: Remove This WPT,
Remove Unused, and Remove Range:
5a. If you select Remove This WPT, the waypoint will immediately
be removed from the Waypoint bank.
5b.If you select Remove Unused, the receiver will delete all
waypoints that are not locked or stored in a route. You will be
prompted to comfirm the deletion:
60
Waypoint
Version 3.3