Eta Setup - Leica MX400 Operating Instructions Manual

Route

ETA Setup

If you choose to use this function, it is probably better to operate the
unit in UTC time mode if you are going to cross one or more time
zones. Note that the time entered uses the offset to UTC applied in
the CFG1 Time display.
The software calculates Estimated Time of Arrival based on how
you configure the unit. ETA settings are controlled from the RTE1
screen. To change the ETA settings:
1. Select the RTE key until the RTE1 screen is displayed.
2. Press the E key.
3. Select the ETA/SOG Calc. softkey.
4. Use the Change softkey to select which value you want the
receiver to calculate, either ETA based on speed, or speed (SOG)
based on desired time and date of arrival.
Version 3.3
Operator's Manual
47