Rte2 - The Route Bank - Leica MX400 Operating Instructions Manual

Route

RTE2 - The Route Bank

The Route Bank is a convenient place for you to preprogram
segments of a long voyage, or to program routes that you follow
over and over again. Creating routes for the Route Bank uses the
same methods as the Active Route with a few exceptions: you can't
use the GOTO key, and you can't use the Plotter screen. You can
use other routes as a subset to create a new route. Remember, you
can always tie routes together in the Active Route by inserting one
after another. You will find a Route Name softkey when you first
enter the edit mode. The Route Name selection allows you to
identify each route by name, number and symbol when you are
viewing the Route Bank from the main menu. To create a route:
1. Select the RTE key until the RTE2 screen is displayed.
2. Move the cursor to the route number you want to create or edit.
3. Press the E key.
4. Use the entry methods described in the Creating A Multi-
Waypoint Active Route section, following the exceptions noted
above.
If you have a route in RTE1 that is not stored in RTE2, you can
copy it into the Route Bank by selecting Insert then Insert
Route, either in the forward or reverse direction.
5. When you are finished selecting waypoints, press the Route
Name softkey.
You can enter any name, number or symbol you want this route
to be identified by.
Version 3.3
Operator's Manual
49