Inserting Waypoints Or Routes Into An Existing Route - Leica MX400 Operating Instructions Manual

Route
The easiest way to accomplish either of these tasks, is to scroll
through the route with the cursor key until the cursor arrow is at the
bottom of the last waypoint you want designated as passed (that is,
white characters on a black background), whether this waypoint
was passed several waypoints ago, or is yet to be passed.
Then press the E key.
Use the up (é) softkey to unpass or the down (ê) softkey to pass
waypoints in the route until the waypoint marked by the cursor is
displayed with white characters on a black background (Daylight
display, see CFG1 Lighting).
Press the E key to end editing.
If for some reason you can't select the waypoint you want (the
screen keeps passing waypoints you unpassed), you are probably
too close to one of the waypoints. You will need to either change
your Waypoint Pass Criteria, change your Waypoint Pass Distance
(see CFG1 Navigation), or remove the waypoint from the route.

Inserting Waypoints or Routes Into An Existing Route

1. Select the RTE key until the RTE1 screen is displayed.
2. Scroll through the route with the cursor key until the cursor
arrow is at the bottom of the waypoint you want to insert the
new waypoint after.
Version 3.3
Operator's Manual
43