Remote Mob - Leica MX400 Operating Instructions Manual

Tide
screens all reflect your bearing and range back to
the MOB position, not
MOB is canceled.
NMEA 0183 sentences (i.e. BWC and BWR) and the printer output
are changed to reflect the current crisis situation by also indicating
the bearing and range back to the MOB position (until the MOB is
canceled). This way, other interfaced equipment can also help guide
you back to the MOB position. When the MOB condition is
canceled, the NMEA sentences will automatically revert to the
active route information. Don't forget to cancel the MOB so your
interfaced equipment will read the correct data!
The MOB function key and remote MOB input are disabled from
subsequent activation, until MOB Cancel is selected.
Other functions such as Position and Navigate can still be accessed;
however, the screen will revert to the MOB Plot screen after 30
seconds.
To cancel a MOB condition, make sure you are in the MOB Plot
screen. Press the E function key, then select the Cancel MOB
softkey. Press E again to exit the edit mode.

Remote MOB

This receiver is also capable of performing the MOB function from
a remote contact closure input via pins 6 and 11 on the 31 pin
connector, shared with the Mark input. If the contact closure is
made for less than 2 seconds, the input is registered as a Mark
Position. If the contact closure is made for more than 2 seconds, the
input is registered as a MOB Position. Refer to the Installation &
Service manual for interface instructions.
Version 3.3
Operator's Manual
the
active route, until the
87