Appendix E - Demonstration Mode - Leica MX400 Operating Instructions Manual

Appendix E - Demonstration Mode

Appendix E - Demonstration Mode
This enables the receiver to function as though you are under way,
even though you are completely stationary. The default setting is
No. When set to Yes, all three Traffic Lights will be illuminated,
and a D symbol is displayed in the upper left corner of every
display. Generally speaking, this feature is used by Leica and your
dealer for show room or trade show demonstrations. However, you
can use it as a training tool until you become familiar with the
receiver. You can also use it to output NMEA 0183 records on the
data ports to test and demonstrate other devices such as autopilots,
chart plotters, and radars.
In the CFG Operation screen activate the Demonstration Mode by
selecting Yes.
Follow:
Active Route: causes the receiver to use the route loaded in
RTE1 screen.
Rhumb Line: causes the receiver to follow the bearing you input
in this screen under Demonstration COG.
Demonstration SOG: causes the receiver to simulate a speed of up
to 99 knots. Slower speeds of 5 to 25 knots provide the best
demonstration results.
Demonstration COG: causes the receiver to simulate a course over
ground of up to 359.9 degrees when Follow is set to Rhumb
Line.
To setup your course, load the desired waypoints into RTE1. Notice
that the receiver loads your point of departure as N 00, W 000.
Version 3.3
Operator's Manual
189