Leica MX400 Operating Instructions Manual page 80

Waypoint
terminal emulation program as Windows 3.11, and we have found it
is not a reliable interface. We suggest that a third party program be
used with Windows 95.
Using Windows Terminal, do the following (from the Program
Manager):
1. Connect the receiver's port 2 RS-232 port to the PC's communi-
cations port (Refer to the Installation & Service Manual)
2. On the receiver, press the CFG key until CFG1 screen is
displayed
3. Scroll down the menu to NMEA Out 2
4. Press the E key
5. If the port is already Active (Yes), write down which NMEA
sentences are set to Yes, then set all of the NMEA sentences to
No. You need to do this to record just the waypoint data.
If the port is not Active (No), change it to Yes
6. Scroll down to the WPL record and change it On
7. Select the Details softkey
8. Set Include Waypoint Names to either No or Yes. Refer to WPL -
Waypoint Location - NMEA Compliant and WPL - Waypoint
With Symbols & Description - NMEA 0183 Non-Compliant
sections in this manual to determine the correct format for your
purpose
9. Set Decimals In Position to 4
10.Press the Done softkey
11.Set the WPL record to Off(you will need to turn the data off
while setting up the computer)
12.On the computer, double click on the Accessories icon
13.Double click on the Terminal icon
14.Click on the Settings menu
15.Double click on the Communications menu item and make the
following settings:
4800 baud
8 data bits
Version 3.3
Operator's Manual
67