Insert Route - Leica MX400 Operating Instructions Manual

Route
5. Choose either Bearing Distance or Lat/Lon (Grid Point, or TD if
you are using other coordinate systems). Use the keypad to type
in the range and bearing from the previous waypoint (or present
position in the case of the first waypoint) or the coordinates you
want and their appropriate description.
6. When the information is correct, press the Done softkey.
7. You can then choose to enter another waypoint using the same
method, select Escape to go back one level and use another
method to enter waypoints, or select Done to go back to the
main menu.
8. Don't forget to press the E key to end your editing.

Insert Route

The following example assumes RTE1 is empty. Follow the
directions in the Erasing An Existing Route section to start with an
empty route if you have waypoints in the RTE1 screen.
To perform this function, you must also have defined a route in the
RTE2 screen. The RTE2 description follows later in the Route
section.
1. Select the RTE key until the RTE1 screen is displayed.
2. Press the E key to enter the edit mode.
3. Select Insert from the display. Skip to the next step if RTE1 is
empty.
4. Select Insert Route from the display.
Version 3.3
Operator's Manual
41