Leica MX400 Operating Instructions Manual page 155

Operator's Manual
This screen controls a few very basic operating settings:
Remember Display: When set to Yes (default), the receiver
remembers the Page Number or screen you viewed the last
time you used a particular function. For example, if you
normally monitor the NAV3 display and you decided to look
at the PLOT1 screen, the next time you press the NAV
function, the receiver will automatically revert to the NAV3
screen immediately.
If you select No for Remember Display, the receiver will
always display the first page of a function when you press
the function key.
Edit Timeout: You can set the timeout limit between None
(default), or 1 to 10 minutes. If you enter the edit mode on
any screen and have a timeout period other than None, the
receiver will automatically exit the edit mode if no keys are
touched and the timeout period expires.
Preceding Zeroes: Places zeroes (0s) before directions less than
100° when Yes is selected. For example 079°. Otherwise
directions are shown without the leading zeros when No is
selected (default). For example 79°.
Beeper: If you attempt to perform a key function that is not
allowed, you normally hear an Error Tone. This is per-
formed when the Beeper is set to On (default). If you don't
want to hear the error or any other keyboard beep, set the
Beeper to Off.
Engineering Display: This enables an expanded series of display
screens in some of the functions. In general, these screens
are used by the technician during troubleshooting, or by
Leica engineers during development testing. Screens which
142
Configuration
Version 3.3