Security; Set & Drift - Leica MX400 Operating Instructions Manual

Configuration
Data Bits: This allows you to match the printer's requirement of 7
or 8 (default) bit serial data.
Stop Bits: This allows you to match the printer's requirement of 1
(default) or 2 stop bits.
Parity Check: This allows you to match the printer's requirement of
No (default), Even or Odd parity.
Handshake: This allows you to match the printer's requirement of
No (default), XON/XOFF or HW (Hardware; CTS, RTS -
requires pins 1, 3, and 5 of the of the Multiport interface
connector) handshaking.

Security

The Security screen allows you to lock out the edit function, to keep
crew members or visitors from changing settings that you have
made. When the security function is enabled, you will be prompted
to enter a 5 diget password. You will then be prompted to re-enter
the password. Once this feature is enabled, a press of the E key in
screen will require the correct password to gain access. The security
function is then disabled until you enter a new password through
the CFG1 Security screen again. Be sure to write your password in
a safe place. If you loose your password, you will need to call the
factory to reset the security feature.
Set & Drift
Set & Drift is obtained one of two ways:
GPS Positioning: Set & Drift is calculated using GPS position,
course and speed over ground, with compass and speed log
inputs to determine the speed and direction of the water (Set &
Drift), when navigating using GPS.
Version 3.3
Operator's Manual
149