Organizer - Automated Message Reminders - Leica MX400 Operating Instructions Manual

Configuration
are relevant for troubleshooting are described in Appendix C
of this manual. The default setting is No. If you should
enable these screens, the receiver will automatically turn
them off the next time power is cycled on the unit.
Demonstration Mode: This enables the receiver to function as
though you are under way, even though you are completely
stationary. The default setting is No. When set to Yes, all
three Traffic Lights will be illuminated, and a D symbol is
displayed in the upper left corner of every display. Gener-
ally speaking, this feature is used by Leica and your dealer
for show room or trade show demonstrations. However, you
can use it as a training tool until you become familiar with
the receiver. As a safety feature, you can not use it to output
NMEA 0183 records on the data ports to test and demon-
strate other devices such as autopilots, chart plotters, and
radars. Refer to Appendix E of this manual for a full
description of the Demonstration Mode.

Organizer - Automated Message Reminders

This screen enables you to program the receiver with up to 25
different message reminders (up to 30 characters in length). You
can program it to alarm for shift changes, log entry intervals,
medication intervals, weather fax updates, etc.
Note: When the Organizer alarm is activated, the
voltage on the Alarm Output Port is also
activated. If you have other devices connected
to this port, you might need to consider what
other systems will be affected when the alarm
sounds. Leica offers an External Alarm controls
software option. Check with your dealer or
Version 3.3
Operator's Manual
143