Setting The Printer Ip Address - Avery Dennison snap 500 Operator's And Service Manual

26

3.7.3 Setting the Printer IP Address

1. Contact your Network Administrator to obtain a static IP address.
2. The default mode is DHCP mode. When attached to the network, the printer will
3. Find the DHCP address by printing a Network ID Test Label.
4. Use a browser such as Internet Explorer and enter the printer's IP address to
5. If moving to another network, set the printer back into DHCP mode. See section
6. See section 5.4.4 for troubleshooting tips on the network connection.
Classification: Avery Dennison - Public
Newer motherboard:
Use this connector
DHCP process may take some time so wait at least one minute after the printer
finishes its initialization with the "Ready" light is on steady before continuing. Do
this only the first time a printer connects to the network.
obtain a DHCP address from the network.

Press and hold the Voice Button until the printer says "Press Start for
Test Patterns."

Press the Start Button

Press the Voice Button until you hear "Press Start for Custom Test
Pattern 1."

Ensure only the top printhead is open.

Press the Start Button

Find the IP address on the resulting label.
access the printer's webserver. Enter the static IP address as described in
section 5.4.2.
5.4.3 for instructions using the webserver.
User's Manual—SNAP™ 500 Gen 1 and Gen 2