Table of Contents
Advertisement
04/02 Rev. 2.15-01
Initiation
Unpacking the printer
1. Remove top foamed packing.
2. Take printer out of cardboard box.
For carrying your printer, take it by the base plate.
Front cover, reel holder and motor of optional knife must not be used as car-
rying handles.
Setting up and connecting the printer
1. Check mains voltage setting and fuses.
– The fuses can be replaced by removal of the fuse element
– Mains voltage variation is possible by turning the insert.
CAUTION!
Mains voltage can kill you!
– Pull off the mains connector befor you check or change the mains voltage
setting!
– Pull off the mains connector befor you check or replace the fuse!
2. Insert current supply into lining designated for this purpose at the rear side
of unit.
3. Switch „ON" of unit.
MANUAL
TTX 207 – Da Capo
Setup, Operation, Service, page 3
(Fig.
1).
Advertisement
Table of Contents
