Power On The Host (Oracle Ilom); Power On The Host (Power Button) - Oracle Netra SPARC T4-1B Service Manual

Related Information
"Power On the Host (Oracle ILOM)" on page 120
■
"Remove the Server Module From the Modular System" on page 61
■

▼ Power On the Host (Oracle ILOM)

Perform this step after the server module is installed in a powered modular system.
1. Install the server module into the modular system.
See
2. Access Oracle ILOM on the SP and run the start /SYS command.
See
Note – The server module power-on process can take several minutes to complete,
depending on the amount of installed memory and the configured diagnostic level.
By default, the server module boots the Oracle Solaris OS.
3. Perform any diagnostics that verify the results of servicing the server module.
Related Information
"Detecting and Managing Faults" on page 5
■
"Power On the Host (Power Button)" on page 120
■

▼ Power On the Host (Power Button)

Perform this step after Oracle's Netra SPARC T4-1B server module is installed in a
powered modular system.
1. Press the Power button on the front of the server module.
See
120 Netra SPARC T4-1B Server Module Service Manual • June 2012
"Install the Server Module Into the Modular System" on page
"Access the SP (Oracle ILOM)" on page
"Front and Rear Panel Components" on page 3
15.
to locate the Power button.
118.