Check For Faults (Fmadm Faulty Command) - Oracle Netra SPARC T4-1B Service Manual

/SP/faultmgmt/0/
faults/0
/SP/faultmgmt/0/
faults/0
->
Related Information
"Diagnostics Process" on page 7
■
"Access the SP (Oracle ILOM)" on page 15
■
"Display FRU Information (show Command)" on page 17
■
"Check for Faults (fmadm faulty Command)" on page 20
■
"Clear Faults (clear_fault_action Property)" on page 21
■
"Service-Related Oracle ILOM Commands" on page 22
■

▼ Check for Faults (fmadm faulty Command)

The following is an example of the fmadm faulty command, which is an alternative
to the show faulty command.
You must run the Oracle Solaris fmadm faulty command from within the Oracle
ILOM faultmgmt shell.
Note – The characters SPT at the beginning of a message ID indicate that Oracle
ILOM detected the fault.
1. At the Oracle ILOM prompt, access the Oracle ILOM faultmgmt shell.
-> start /SP/faultmgmt/shell
Are you sure you want to start /SP/faultmgmt/shell (y/n)? y
2. At the faultmgmtsp> prompt, type the fmadm faulty command.
faultmgmtsp> fmadm faulty
------------------- ------------------------------------ ------------ -------
Time
------------------- ------------------------------------ ------------ -------
2011-08-11/14:54:23 ********-****-****-****-******* SPT-8000-LC
...
20 Netra SPARC T4-1B Server Module Service Manual • June 2012
| fru_serial_number
|
| fru_part_number
|
UUID
| 465769T+**********
|
| 7015272
|
msgid Severity
Critical