Configure Post - Oracle Netra SPARC T4-1B Service Manual

Oracle ILOM Parameter
/HOST/diag trigger
/HOST/diag verbosity normal
Description of POST
execution
* The keyswitch_state parameter, when set to diag, overrides all the other POST variables.
Related Information
"POST Overview" on page 29
■
"Configure POST" on page 33
■
"Run POST With Maximum Testing" on page 35
■
"Interpret POST Fault Messages" on page 37
■
"Clear POST-Detected Faults" on page 37
■
"POST Output Reference" on page 39
■

▼ Configure POST

1. Log in to Oracle ILOM.
See
2. Set the virtual keyswitch to the value that corresponds to the POST
configuration you want to run.
The following example sets the virtual keyswitch to normal, which will configure
POST to run according to other parameter values.
-> set /SYS keyswitch_state=normal
Set 'keyswitch_state' to 'Normal'
For possible values for the keyswitch_state parameter, see
Properties That Affect POST Behavior" on page
Normal Diagnostic Mode
(Default Settings)
hw-change error-reset
This is the default POST
configuration. This
configuration tests the server
module thoroughly and
suppresses some of the
detailed POST output.
"Access the SP (Oracle ILOM)" on page
No POST Execution
none
POST does not run,
resulting in quick
initialization. This
configuration is not
suggested.
15.
30.
Detecting and Managing Faults
Service Mode Using the
Keyswitch_state
POST runs the full
spectrum of tests with
the maximum output
displayed.
"Oracle ILOM
33