Power On The Host Using The Power Button; Power The Host On And Off Using Oracle Ilom - Oracle Server X6-2 Installation Manual

Power On the Host Using the Power Button

1. Verify that the server is in standby power mode.
See "Preparing for Installation and Power On" on page
In Standby power mode, the host is powered off but the SP is powered on. The power supplies
are connected to a power source, the AC OK power supply indicator lights, the SP OK indicator
is steady on, and the Power/OK status indicator flashes slowly.
Locate the Power button on the front panel.
2.
3. Press the Power button.
The host boots and the server enters full power mode. The system Power/OK indicator goes
steady on when the host is fully booted.

Power the Host On and Off Using Oracle ILOM

This procedure provides Oracle ILOM web and command-line interface (CLI) instructions to
remotely power on or power off the host.
Data loss. An immediate shutdown abruptly closes all applications and files without
Caution -
saving changes.
Control power using the Oracle ILOM web interface or the CLI.
You must be logged on with administrator privileges. For details, see
ILOM" on page 79.
From the web interface:
■
These commands affect power to the host but not to the SP. To completely power off the
Note -
server, you must disconnect the power cords from the back panel of the server.
a. In the left pane, click Host Management → Power Control.
b. From the Select Action list box, select one of the following:
Reset — Assert a power-cycle to a managed server, while keeping power applied
■
to system components such as disk drives.
Power On the Host Using the Power Button
74.
"Connecting to Oracle
Controlling System Power 99