Table of Contents
Advertisement
■
■
3. (If needed) Remove the drive filler from this slot.
See
4. Slide the drive into the bay until it is fully seated (panel 1).
5. Close the latch to lock the drive in place (panels 2 and 3).
6. Verify the functionality of the new drive.
See
Related Information
"Remove a Drive" on page 69
■
72
Netra SPARC T4-1B Server Module Service Manual • June 2012
If you are replacing a drive, ensure that you install the replacement drive in the
same slot as the drive you removed.
If you are adding an additional drive, install the drive in the next available
drive slot.
"Remove a Drive Filler" on page
"Verify Drive Functionality" on page
70.
74.
Advertisement
Table of Contents
Need help?
Do you have a question about the Netra SPARC T4-1B and is the answer not in the manual?
Questions and answers