Powering On The Host; Power On The Host (Oracle Ilom) - Oracle SPARC T5-1B Service Manual

Powering On the Host

The front panel LEDs blink three times, then the green OK LED on the front panel blinks
■
for a few minutes.
Oracle ILOM is initialized on the server module SP and is ready to use, but the server
■
module host is not started.
Start the server module host.
7.
See "Powering On the Host" on page
Related Information
"Powering On the Host" on page 102
■
"Remove the Server Module From the Modular System" on page 48
■
Powering On the Host
Use one of these tasks to power on the host:
"Power On the Host (Oracle ILOM)" on page 102
■
"Power On the Host (Power Button)" on page 103
■
Related Information
"Install the Server Module Into the Modular System" on page 100
■

Power On the Host (Oracle ILOM)

1. (If needed) Install the server module into the modular system.
See "Install the Server Module Into the Modular System" on page
2. Log into Oracle ILOM.
See "Log Into Oracle ILOM (Service)" on page
Note -
the amount of installed memory and the configured diagnostic level.
By default, the server module boots the Oracle Solaris OS.
102 SPARC T5-1B Server Module Service Manual • February 2019
The server module power-on process can take several minutes to complete, depending on
102.
21.
100.