Display System Components - Oracle Netra SPARC T4-1B Service Manual

Server module

Table of Contents

Note – The asrkey values vary from system to system, depending on how many

cores and memory are present. Use the show components command to see the

asrkey values on a given system.

After you enable or disable a component, you must reset (or power cycle) the server

module for the component's change of state to take effect. See the SPARC and Netra

SPARC T4 Series Servers Administration Guide

Related Information

"Display System Components" on page 47

■

"Disable System Components" on page 48

■

"Enable System Components" on page 49

■

▼ Display System Components

The show components command displays the system components (asrkeys) and

reports their status.

●

At the Oracle ILOM prompt, type show components.

In the following example, one of the DIMMs (BOB1/CH0/D0) is shown as

disabled.

->show components

Target

--------------------+------------------------+-------------------------------

/SYS/MB/REM

/SYS/MB/FEM0

/SYS/MB/CMP0/L2T0

/SYS/MB/CMP0/L2T1

/SYS/MB/CMP0/L2T2

/SYS/MB/CMP0/L2T3

/SYS/MB/CMP0/L2T4

/SYS/MB/CMP0/L2T5

/SYS/MB/CMP0/L2T6

/SYS/MB/CMP0/L2T7

/SYS/MB/CMP0/CORE0/ | component_state

<...>

| Property

| component_state

| Value

| Enabled

Detecting and Managing Faults

Table of Contents