Setting Sp Policy For Host Power At Boot (Oracle Ilom); Set Sp Host Power Policy At Boot - Oracle X7 series Administration Manual

■
■
■
3.
If you are prompted to confirm your choice, type y, and then press Enter.
Related Information
Controlling Host Power, Oracle ILOM Administrator's Guide for Configuration and
■
Maintenance, Firmware Release 4.0.x

Setting SP Policy for Host Power at Boot (Oracle ILOM)

By default, when AC power is applied to the server, the server enters Standby power mode.
However, it is possible to change this default power state by configuring a power-on policy in
Oracle ILOM.

Set SP Host Power Policy at Boot

Before you perform the following procedure, ensure that you have Admin (a) role privileges in
Before You Begin
Oracle ILOM.
1. To set a power-on policy in the Oracle ILOM web interface, perform the following
steps:
Log in to the Oracle ILOM web interface.
a.
For instructions, see
b. In the navigation pane, click System Management → Policy.
c. In the Service Processor Policies table, select one of the following policies:
■
To gracefully shut down the server, type
To immediately shut down the server, type
To power on the server, type
"Accessing Oracle ILOM" on page
Auto power-on host on boot
Setting SP Policy for Host Power at Boot (Oracle ILOM)
stop /System
stop -f /System
.
start /System
21.
Controlling the Server Power State
.
.
45