Setting Sp Policy For Host Power At Boot (Oracle Ilom); Set Sp Host Power Policy At Boot - Oracle X6 series Administration Manual

■
■
3.
If you are prompted to confirm your choice, type y, and then press Enter.
Related Information
Controlling Host Power, Oracle ILOM Administrator's Guide for Configuration and
■
Maintenance, Firmware Release 3.2.x

Setting SP Policy for Host Power at Boot (Oracle ILOM)

By default, when AC power is applied to the server, the server enters Standby power mode.
However, it is possible to change this default power state by configuring a power-on policy in
Oracle ILOM.
Before you perform the following procedure, ensure that you have Admin (a) role privileges in
Oracle ILOM.

Set SP Host Power Policy at Boot

To set a power-on policy in the Oracle ILOM web interface, perform the following
1.
steps:
a. Log in to the Oracle ILOM web interface.
For instructions, see
b. In the navigation pane, click System Management > Policy.
c. In the Service Processor Policies table, select one of the following policies:
■
■
The power on policies are mutually exclusive, that is, only one can be enabled at a time.
For more information about each policy, click the More Details link at the top of the page.
To immediately shut down the server, type
To power on the server, type
"Accessing Oracle ILOM" on page
Auto power-on host on boot
Set host power to last power state on boot
Setting SP Policy for Host Power at Boot (Oracle ILOM)
stop -f /System
.
start /System
21.
Controlling the Server Power State
.
43