Table of Contents
Advertisement
3. Tilt the FEM up (panel 2).
4. Remove the FEM (panel 3) and place the FEM on an antistatic mat.
5. (If needed) Install a FEM.
See
Related Information
"Install a FEM" on page 94
■
▼ Install a FEM
This procedure applies to any of the form factors of FEM cards that are supported by
this server module.
94
Netra SPARC T4-1B Server Module Service Manual • June 2012
"Install a FEM" on page
94.
Advertisement
Table of Contents
Need help?
Do you have a question about the Netra SPARC T4-1B and is the answer not in the manual?
Questions and answers