Oracle Netra SPARC T4-1B Service Manual page 95

e. Switch to the host console and type the Oracle Solaris OS fmadm faulty
command.
# fmadm faulty
No memory faults should be displayed.
If faults are reported, refer to the
approach to diagnose the fault.
5. Switch to the Oracle ILOM prompt.
6. Type the show faulty command.
If the fault was detected by the host and the fault information persists, the
■
output will be similar to the following example:
-> show faulty
Target
--------------------+------------------------+-------------------------------
/SP/faultmgmt/0
/SP/faultmgmt/0
/SP/faultmgmt/0/
faults/0
/SP/faultmgmt/0/
faults/0
/SP/faultmgmt/0/
faults/0
If the show faulty command does not report a fault with a UUID, the fault is
■
cleared. You do not need to proceed with the following steps.
7. (Only if previous steps did not clear the fault) Type the set command.
-> set /SYS/MB/CMP0/BOB0/CH0/D0 clear_fault_action=true
Are you sure you want to clear /SYS/MB/CMP0/BOB0/CH0/D0 (y/n)? y
Set 'clear_fault_action' to 'true'
8. (Only if previous steps did not clear the fault) Switch to the host console and
type the fmadm repair command with the UUID.
Use the same UUID that was displayed from the output of the Oracle ILOM show
faulty command.
# fmadm repair 3aa7c854-9667-e176-efe5-e487e5207a8a
Related Information
"Install a DIMM" on page 81
■
| Property
| fru
| timestamp
| sunw-msg-id
|
| uuid
|
| timestamp
|
"Diagnostics Process" on page 7
| Value
| /SYS/MB/CMP0/BOB0/CH0/D0
| Dec 14 22:43:59
| SUN4V-8000-DX
|
| 3aa7c854-9667-e176-efe5-e487e520
| 7a8a
| Dec 14 22:43:59
|
for an
Servicing Memory 85