Oracle Netra SPARC T4-1B Service Manual page 94

b. Power cycle the server module.
-> stop /SYS
Are you sure you want to stop /SYS (y/n)? y
Stopping /SYS
-> start /SYS
Are you sure you want to start /SYS (y/n)? y
Starting /SYS
Note – The server module takes about one minute to power off. Use the show
/HOST command to determine when the host has been powered off. The console will
display status=Powered Off.
c. Switch to the host console to view POST output.
-> start /HOST/console
.
.
.
0:0:0>INFO:
0:0:0>
0:0:0>POST:
0:0:0>Master set ACK for vbsc runpost command and spin...
Note – Depending on the configuration of Oracle ILOM variables that affect POST
and whether POST detected faults or not, the server module might boot, or the server
module might remain at the ok prompt. If the server module is at the ok prompt,
type boot.
d. Return the virtual keyswitch to Normal mode.
-> set /SYS keyswitch_state=Normal
Set 'ketswitch_state' to 'Normal'
84 Netra SPARC T4-1B Server Module Service Manual • June 2012
Watch the POST output for possible fault messages. The following output is a
sign that POST did not detect any faults:
POST Passed all devices.
Return to VBSC.