Triumph Thunderbird Service Manual page 91

Clutch
4. Release the ring of bolts securing the clutch cover to
the crankcases.
Installation
Ensure that the lifter piece rack engages
correctly with the lifter arm pinion during
assembly. It may be necessary to rotate the
lifter piece rack to allow assembly to take
place.
Fit and tighten the bolts to 9 Nm. Tighten the bolts
in
a diagonal sequence.
Refit the control plate assembly, tightening the bolts
to SO Nm.
6.
cfuf
5.
•
1. Gear change shaft
2. Flat washer
3. Wavy washer
2. Thoroughly clean the cover and crankcase mating
faces.
3.
Position a new gasket to the crankcase.
4. Refit the cover ensuring that the gasket does not
become dislodged.
Note:
1.
Ensure the wavy washer and flat washer are correctly
~ ~
on the gear change shaft
Note the position of the wavy washer and flat washer
on the gear change shaft
z
cfub
1. Clutch cover
2. Bolt
5.
Place an oil catch tray beneath the clutch cover to
collect any oil that may spill out on removal.
6. Carefully withdraw the cover.
cfuf
1. Gear change shaft
2. Flat washer
3. Wavy washer
SelVice Manual - Thunderbird
4.7