Installation - Triumph Thunderbird Service Manual

Electrical System
Damage to painted surfaces could result from
inadequate care during removal or installation of the
starter motor. Always protect the crankcase from
damage during removal or installation.
2. Carefully position the starter to the crankcase and
retain with the two bolts. Tighten the bolts to
28Nm.
3. Remove any self adhesive tape used to protect the
crankcase.
4. Reposition the throttle body hose clip and tighten to
1.5 Nm.
5. Incorporating a new copper washer, refit the
breather spout and tighten to
35 Nm.
6. Align the main engine ground cable to the crankcase
and secure with the bolt. Tighten to
7 Nm.
Z Locate the starter cable to its connection pole. Fit the
nut and tighten it to 7 Nm.
8. Refit the boot.
9. Reconnect the solenoid to the main harness.
10. Reconnect the battery, positive (identified with red
tape) lead first.
11. Refit the rider's seat (see page 17-9).
Damage to painted surfaces could result from
inadequate care during removal or installation of the
starter motor. Always protect the crankcase from
damage during removal or installation.
cfmo
1. Starter motor
2. Bolts
11. Carefully manoeuvre the starter motor out to the
right hand side of the motorcycle.
10. Release the two bolts securing the starter motor to
the crankcase.
Installation
1. Fit a new O-ring to the starter motor.
Arrowed - O-ring
18.20
Service Manual- Thunderbird