Triumph Thunderbird Service Manual page 261

Installation
1. If removed, refit the intake duct. Tighten the hose
clips to 1.5 Nm.
2. Position the airbox to the air intake duct, ensuring
the duct is correctly aligned to the airbox. Clip the
roll over valve to the right hand side of the airbox.
3. Check that the harnesses and hoses are routed as
noted on disassembly
4. Secure the airbox with the four fixings and tighten to
9Nm.
5. Tighten the intake duct clip to 1.5 Nm.
6. Refit both rear suspension units (see page 14-4).
Z Refit the relay bracket, ensuring the harness is not
trapped, and secure with the two fixings. Tighten to
7Nm.
8. Refit the relays to the relay bracket, in the position
noted during removal.
9. Reposition the fuse box to the relay bracket, and
secure with new fir-tree clips.
10. Reconnect the barometric pressure sensor connector.
11. Reconnect the fall detection switch connector.
12. Ensuring the wiring is not trapped, refit the fall
detection harness cover and secure with a new fir-
tree clip.
13. Reconnect the intake air temperature sensor
connector.
14. Refit the ECM (see page 10-971.
15. If fitted, refit the SAl valve to its bracket and
reconnect the SAl hose to the airbox.
16. Ensure the wiring to both sides of the airbox is
routed as noted during removal.
lZ Reconnect the engine breather hose to the airbox.
18. Refit the air filter element (see page 10-95>.
19. Refit the rear mudguard (see page 17-10>.
20. Refit the rear wheel (see page 16-8>.
21. Refit both side panels (see page 17-9).
22. Refit the fuel tank (see page 10-98>.
23. Refit the battery (see page 18-9).
24. Refit the rider's seat (see page 17-9).
Fuel System/Engine Management
ECM
Removal
1. Remove the rider's seat (see page 17-8>.
2. Disconnect the battery, negative (black> lead first.
3. Remove the left hand side panel (see page 17-9).
4. If fitted, disconnect the secondary air injection (SAD
hose from the SAl valve.
5. Remove the two fixings and detach the ECM
bracket.
\J~
oogo
~~==='::~~
1. ECM bracket
2.
Fixings
6. Detach the ECM from the airbox and disconnect the
two electrical connectors (see page 10-33).
Z Remove the ECM.
SelVice Manual - Thunderbird
10.97