Input And Output Shaft Assemblies; Installation; Removal - Triumph Tiger Service Manual

( \
, I
\ !
o
C)
INPUT AND OUTPUT SHAFT ASSEMBLIES
Removal
The input and output shafts can be lifted out of the lower
crankcase after the crankcase halves have been
separated. For details of crankcase separation, refer to
the crankcase section.
Installation
Ensure the bearing sleeve dowels, oil seal and retaining
rings are correctly located when refitting both shafts.
NOTE:
•
Apply a small amount of 'Loctite 648' to the
bearing locations in the upper crankcase before
fitting the assembled transmission shafts.
Ensure that all gears are correctly meshed.
1. Output Shaft Dowel (Clutch Side)
2. Crankcase Location
7.17
TRANSMISSION 7
gaal
1, Input Shaft Dowel (drive sprocket side)
2. Crankcase Location
1. Oil seal
2. Semi-circular Retaining Ring
(Output Shaft Illustrated)
NOTE:
•
It is recommended that the semi-circular input
shaft retaining ring (adjacent to the clutch) is
positioned to engage an equal amount in the
upper and lower crankcases.